Ricoh D131 Service Manual page 1003

Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types of
remote terminal ID when
printing reports
7 0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI
> CSI
No Function
Automatic port selection
0
0: Disabled, 1: Enabled
1-3 Not used
Dialing on the ten-key pad when
the external telephone is
4
off-hook
0: Disabled 1: Enabled
On hook dial
5
0: Disabled 1: Enabled
SM
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
Note: The memory size is limited. Use this bit
switch only when some log reports are
necessary.
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored, by the user, for
the Quick/Speed Dial number.
System Switch 0A (SP No. 1-101-011)
When "1" is selected, a suitable port is
automatically selected if the selected port is not
used.
NOTE: This bit is useful if all communication
lines at a customer site are not the same
quality
Do not change these settings.
0: Prevents dialing from the ten-key pad while
the external telephone is off-hook. Use this
setting when the external telephone is not by
the machine, or if a wireless telephone is
connected as an external telephone.
1: The user can dial on the machine's ten-key
pad when the handset is off-hook.
0: On hook dial is disabled.
Comments
111 D619