Ricoh D131 Service Manual page 1106

Memory Transmission and Parallel Memory Transmission
The base copier's scanner scans the original at the selected resolution in inch format. The IPU
processes the data and transfers it to the FCU.

When scanning a fax original, the IPU uses the MTF, independent dot erase and
threshold parameter settings programmed in the fax unit's scanner bit switches, not the
copier's SP modes.
Then, the FCU converts the data to mm format, and compresses the data in MMR or raw format to
store it in the SAF memory. If image rotation will be done, the image is rotated in page memory
before compression.
At the time of transmission, the FCU decompresses the stored data, then re-compresses and/or
reduces the data if necessary for transmission. The NCU transmits the data to the line.
Immediate Transmission
The base copier's scanner scans the original at the resolution agreed with the receiving terminal.
The IPU video processes the data and transfers it to the FCU.

When scanning a fax original, the IPU uses the MTF, independent dot erase and
thresholding parameter settings programmed in the fax unit's scanner bit switches, not
the copier's SP modes.
Then the FCU stores the data in page memory, and compresses the data for transmission. The
NCU transmits the data to the line.
JBIG Transmission
Memory transmission: If the receiver has JBIG compression, the data goes from the DCR to the
QM-Coder. Then the NCU transmits the data to the line. When an optional G3 unit (SG3) is
installed and PSTN2 is selected as the line type, JBIG compression is available, but only for the
PSTN-2 line.
Immediate transmission: If the receiver has JBIG compression, the data goes from the page
memory to the QM-Coder. Then the NCU transmits the data to the line. When an optional G3 unit
(SG3) is installed and PSTN2 is selected as the line type, JBIG compression is available, but only
for the PSTN-2 line.
Adjustments

Priority for the line used for G3 transmissions (PSTN 1/PSTN 2 or 3): System switch 16 bit 1
D619 214 SM