Ricoh D131 Service Manual page 1001

0 1
1 0
1 1
No Function
Length of time that RDS is
0
temporarily switched on when
to
bits 6 and 7 of System Switch
7
02 are set to "User selectable"
No Function
0-2 Not used
Printing dedicated TX
parameters on Quick/Speed
3 Dial Lists
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
SM
User selectable will automatically be locked out again after a
certain time, which is stored in System Switch
User selectable
03. Note that if an RDS operation takes place,
RDS will not switch off until this time limit has
Always enabled
expired.
(1,1): At any time, an RDS system can access
the machine.
System Switch 03 (SP No. 1-101-004)
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of
System Switch 02 are set to "User selectable".
The default setting is 24 hours.
System Switch 04 (SP No. 1-101-005)
Do not change these settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated TX parameters (10
bytes each).
The first 10 bytes of data are the programmed
dedicated TX parameters; 34 bytes of data are
printed (the other 24 bytes have no use for
service technicians).
Do not change these settings.
Comments
Comments
109 D619