Appendix C - Pan-Oston Po-4 - NCR RealScan 7875-7000 Installation Manual

This checkstand has a metal side panel next to the scanner position. A hole must be cut in this
panel and covered with a Plastic Side Plate.
1. Use a saw to cut out a portion of the metal side panel that is 13" long and 3 ½ " deep. This
2. Use two bolts to connect the Cover Rail (NCR Part Number 497-0430977) to the Plastic
3. Attach the new Side Plate assembly to the checkstand using four screws.
4. Install a Sensormatic Power Pad Label on the Plastic Side Plate. Remove the paper backing
5. Go to Step 2 – Connect the Components.
AIP-00342 Release B
Appendix C – Pan-Oston PO-4
should start 1.15" from the front edge of the side panel.
Side Plate (NCR Part Number 497-0430978).
and place the label in the middle of the Plastic Side Plate.
06/03
NCR RealScan 7875-7000/8000 Installation Guide
49 of 56