Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7702-K168
Summary of Contents for NCR 7702-K168
- Page 1 KIT INSTRUCTIONS Imaging Scanner 7702-K168 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
Imaging Scanner This kit contains the components to add an Imaging Scanner to the 15" display of the RealPOS XR7 POS. Kit Contents... -
Page 4: Installation Procedure
Imaging Scanner Installation Procedure Note: This kit restricts access to certain ports and the only cables allowed on this set–up are the following: • Power Cable • Ethernet Cable • Serial Adapter Cable • 24V Powered USB Cable • 12V Powered USB Cable •... - Page 5 Imaging Scanner 2. Open the Cable Cover and remove the two screws. 3. Install the display mounting bracket on the Display Collar using the SEMS screws (2) that are included in the kit.
- Page 6 Imaging Scanner 4. Connect the Type A end of the USB Cable to the Motherboard. Route the other end of the USB cable through the Cable Cover then close it. 5. Screw the imager mounting bracket on the Imaging Scanner (3 screws).
- Page 7 Imaging Scanner 6. Connect the USB cable to the Imaging Scanner. a. Route the USB cable through the cable management features of the imager mounting bracket. b. Connect the Right Angled Micro–B end of the USB cable to the Imaging Scanner and route the cable through the strain reliefs.