Check Sensormatic Deactivation System
Position a Hard Tag above the RealScan 7875 Top Plate. As you move the tag within 4 inches of
the Top Plate you should hear a clicking sound. If the Hard Tag is less than 4 inches from the
Top Plate, consult the Sensormatic Card – Before You Call About...
Next, obtain a security tag that has not been deactivated. Scan a bar code and immediately pass
the security tag through the deactivation zone. The Good Read Tone should sound indicating a
good read of the barcode and deactivation of the security tag. Refer to the Operating the
Sensormatic Deactivation System section for detailed operating instructions.
Call Sensormatic
If you chose to purchase an EAS component from NCR with your NCR Scanner/Scale, please be
aware that the EAS device requires on-site testing and tuning by your EAS supplier who
performs this service for a fee. If your NCR Scanner/Scale does not include an EAS device and
you wish to add one after your scanner purchase, you must purchase the EAS device and testing
and tuning services from your EAS supplier.
Please contact your Sensormatic representative or call 1 (800) 241-6678.
AIP-00342
Release B
X Axis Orientation
4" Above Top Plate
06/03
NCR RealScan 7875-7000/8000 Installation Guide
Y Axis Orientation
4" Above Top Plate
20788
29 of 56