Connect Remaining Components - NCR RealScan 7875-7000 Installation Manual

Connect Remaining Components

Locate the NCR RealScan 7875 Power Supply in position in the checkstand where spilled liquid
cannot contact it. The system configuration may also include a Remote Display and an RS-232
peripheral such as a hand-held scanner. The following illustration shows how all cables are
connected. Be sure to route these cables properly through the checkstand. After all cables are
connected, plug in the NCR RealScan 7875 and the Sensormatic ScanMax
Power Cords to supply power to the units.
AC
Power
Cord
AIP-00342 Release B
Check switch settings
Power
Supply
DC
Power
Cable
Remote
Interface
Display
Cable
06/03
NCR RealScan 7875-7000/8000 Installation Guide
DUAL PERIPHERAL PORTS
PORT 1
RealScan 7875
TM
Pro Controller
PORT 2
AC
Sensormatic
Power
Antenna
Cord
Cable
MNS
STATUS PROG BR EXPANSION BCAN I/O POS SERVICE REMOTE
Sensormatic
Sensormatic ScanMax™
Communications Cable
Pro Controller
Host
Terminal
ANTENNA
RS-232
Peripheral
20553
15 of 56