Step 2 - Connect The Components; Install Sensormatic Antenna - NCR RealScan 7875-7000 Installation Manual

Locate the Sensormatic ScanMax
spilled liquids cannot contact it.

Install Sensormatic Antenna

Note: The Sensormatic ScanMax
scanner.
The Sensormatic ScanMax
7875. It should always be placed on the trailing side. If the installation is setup to scan from
right-to-left, put the Sensormatic Antenna on the left side of the scanner as shown in the
illustration.
1. Feed the Sensormatic Antenna Cable through the large hole in the front of the Mounting
2. Carefully place the Sensormatic Antenna in position, setting it on the Sub Plate.
3. Route the Sensormatic Antenna Cable down through the slot in the front of the Mounting
AIP-00342 Release B
TM
NS Pro Antenna can be positioned on either side of the RealScan
Bracket (bucket). This must be the hole on the side where you are installing the antenna.
Note: Depending on the checkstand configuration, you may have to slide the back of the
Antenna under the Produce Guard if one is included. The Antenna must not interfere with
Produce Guard movement.
Bracket (bucket).
06/03
NCR RealScan 7875-7000/8000 Installation Guide
Step 2 – Connect the
AC Power Connector
Antenna Connector
Communications Connector (POS)
TM
Pro Controller inside the checkstand in a position where
TM
NS Pro Antenna is very heavy; do not to drop it in the
Components
13 of 56
20588