Table of Contents
Advertisement
NCR RealScan 7875-7000/8000 Installation Guide
Align the RealScan 7875 to the Checkstand
The measurements in this section refer to efficiency of scanning, by eliminating exposed edges
which would catch a product during the recommended "power slide" scanning technique thus
slowing down the cashier. Scaling requirements are quite separate and less vigorous, per the
section above: "Install RealScan 7875".
FOR EFFICIENT SCANNING:
The leading edge of the Top Plate must be flush or up to 1/16 in. (0.15 cm) below the top of the
checkstand. The trailing edge of the Top Plate must be flush or up to 1/16 in. (0.15 cm) above
the top of the checkstand.
Note: The four adjustable support posts on the Scale Support Bar Assembly are set at the
factory. Do not attempt to adjust the Top Plate using these posts. Adjust the checkstand supports
to align the Top Plate with the checkstand.
If the Top Plate is properly aligned with the checkstand, an item should easily slide from the
checkstand onto the Top Plate and then from the Top Plate onto the checkstand. The following
illustration shows this alignment.
20 of 56
Top Plate
06/03
20571B
AIP-00342
Release B
Hide quick links:
Advertisement
Table of Contents
