Introduction To Icore - A Crash Course (Not Literally); Going On-Line For The First Time - MC2 Audio ti series Instruction Manual

Introduction to ICORE – a crash course (not literally)

Going on-line for the first time

Having physically connected all devices to the computer through a suitable RS485
converter, and installed the software successfully, we now need to check the
virtual COM port that the converter is using so we can match this with the COM
port in ICORE.
With the converter plugged in (the COM port won't show up if the converter
isn't connected!) use the shortcut of the Windows key on your keyboard + the
Pause/Break key to bring up the System properties window:
Press BOTH keys together! Alternatively you can get to the same place through
start Settings
Make a note of this port number and then, open ICORE.
Amplifier Operator's Manual
Control Panel System
Press the "Hardware" tab and then "Device
Manager". This will bring up a window with a list of
all hardware subsections of your computer,
including the COM ports. Expand the section
entitled "Ports" and locate the USB-Serial adapter.
The COM port number it has been assigned is in
brackets after the name.
Page 25