Table of Contents
Advertisement
Pressing "Open" when the file has been located will start the load procedure
immediately. The COMMS LED on the amplifier will begin to flash quickly in
yellow. The load will take under 90 seconds. When complete the HyperTerminal
window will show
Page 60
and the amplifier will reboot.
You may keep the window open and
repeat the procedure for any other
connected amplifiers – the program
will remember the location of the hex
file.
It is recommended that you save the
settings in HyperTerminal if you might
need to boot-load any other devices.
Amplifier Operator's Manual
Advertisement
Table of Contents
