Front Panel Controls and Indicators
1: Limit Indicators
2: Power Switch
Page 14
Ti Series
The
amplifiers incorporate signal limiters,
which are preset to prevent clipping with high levels
of drive. The LEDs on the front panel illuminate to
indicate operation of the limiters.
This switch turns off the amplifier completely, by
switching off the auxiliary supply that is responsible
for keeping the microprocessor alive when the main
amplifier is in standby mode. A green LED is visible
through the right hand ventilation hole when the
amplifier is connected to the mains and turned on.
The "POWER" LED on the front panel will be red if
the amplifier is in standby, and green when active.
Amplifier Operator's Manual