Table of Contents
Advertisement
Bridged (Mono) Operation
Supply the signal to Channel A input only & select "Bridge Mode" by pressing the
"MODE" switch until the "Bridge" LED is illuminated.
Use Channel A Output Speakon connector and connect as follows:
Ti-4250: Bridge mode only operable on channel C&D, using channel C's Speakon
When operating in bridged mode, the minimum impedances are doubled. The
minimum load in bridged mode is: 8 ohms - T3500, 4 ohms - T2000.
Reset Switch
9:
Amplifier Operator's Manual
PIN 2+: HOT
PIN 1-: COLD
PIN 2+: HOT
PIN 1-: COLD
This recessed momentary action switch is used to
reset the amplifier back to default settings. Please
see the section on page 53 for more information.
Page 21
Advertisement
Table of Contents
