Table of Contents
Advertisement
The loader will start scanning for all connected devices to determine what unit it
has to update. After a few seconds the amplifier will be found and identified (its
Power LED will begin to flash yellow). Check the model number which will be
shown in the status pane, and if OK, press the "Load" button.
If the amplifier is active it will power down immediately, and the update will start.
DO NOT START ANY OTHER PROGRAMS DURING THE UPDATE!
DO NOT DISCONNECT THE AMPLIFIER DURING THIS PROCEDURE!
During the update the "limit" LEDs will be illuminated and the Comms LED will
flicker. The update takes less than 90 seconds and when complete, the amplifier
will reboot automatically, and a message will confirm that the update is complete.
Remember that units cannot be updated over the audio transport bridge (i.e. via
a breakout box, and must be directly connected to the RS485 network from the
computer.
Amplifier Operator's Manual
If there are multiple units to
update, then simply turn off the
completed one and switch on the
iCore
next one –
before and just press "Load"
again to update the unit.
Repeat this procedure for all units
as required.
will find it as
Page 57
Advertisement
Table of Contents
