Table of Contents
Advertisement
Additional Amplifier Properties
All other amplifier properties that are not directly related to audio and real time
control are listed in the Properties window. These are:
General:
ID: This is the amplifier's unique serial number (Read only)
Amp Name: Click to edit the name of the amplifier
Firmware version: Currently running amp firmware (Read only)
Channel names: Click to edit channel names
Power on Delay: Enter a time from 0 to 60 seconds to adjust the
time between standby and on. See the section on page 14 for more
information.
Front Panel Pots: Enabled/Disabled (Read only) Please see page
49 for how to adjust this internally in the amplifier.
Alarm Temp. Threshold: Set threshold to trigger alarm output
GPIO Config: Input: Choose how the general purpose input line behaves.
Output: Choose how the general purpose output line behaves.
Aux Relay: Enable or disable the relay following the G.P. Out line.
Impedance Alarms: Ch1 Value: Value updated automatically – see page 45
Amplifier Operator's Manual
Mute Enable – See page 38
Standby Enable – See page 43
VCA Mode – See page 42
Delay Disable – Bypass Power on Delay
Trim Bypass – Set Digital Pots to 0dB
A/P Monitor: Triggered by amp going into protect
Temp. Alarm: Triggered if temperature > threshold
Limiters Monitor: Triggered if either channel in
continuous limit for > 15 minutes
Load Monitor Alarm: Triggered if a programmed load
reference goes out of range - See page 45
Ch1 Window %: Set maximum deviation from value
Ch2 Value: Value updated automatically – see page 45
Ch2 Window %: Set maximum deviation from value
Ch3 Value: Value updated automatically – see page 45
Ch3 Window %: Set maximum deviation from value
Ch4 Value: Value updated automatically – see page 45
Ch4 Window %: Set maximum deviation from value
(Ti-4250 only)
Page 35
Advertisement
Table of Contents
