Table of Contents
Advertisement
6: A/P (Audio Protect) – Fault Indicator
If the outputs are shorted or if DC is present, the protection circuit
will disengage the outputs and the "A/P" LED will illuminate. The
amplifier will continue to be monitored and depending on the type
of fault, will either reset after the fault has cleared or require manual resetting by
switching off at the mains switch and then on again after a few seconds.
Temperature related faults will reset if the unit has cooled sufficiently.
Output short circuits will require manual reset after clearing the fault.
Please note that it is quite normal for the "A/P" LED to illuminate for a short
during start-up or coming out of standby mode.
7: Signal Indicators
Page 16
These are active from a minimum output level of
approximately 10 Watts and are an indication only of
signal presence.
Amplifier Operator's Manual
Advertisement
Table of Contents
