Table of Contents
Advertisement
Front Panel Indicators
4
1
2
3
1: Power On Indicator
This illuminates shortly after power up, following the system checks, and shows
that the network card is present and functioning correctly. One flash at start-up
means 48kHz sample rate, two flashes means 96kHz. Please see page 35 for how
this can be changed. This LED will also flash when the unit is scanned when
going on-line remotely with ICORE, or if the "Identify" button is pressed.
Please see page 12 for more details of this feature.
2: Network Indicators
The "Link" and "Activity" LEDs follow those on the network card and will
illuminate when a network connection is present and detected by the card.
3: RS485 Comms Indicators
The RX and TX LEDs show comms activity on the RS485 bus, and are also used in
conjunction with the the Network LEDs to show master mode configuration on
start-up – see page 33 for more details of this.
4: Network Type Badge
The badge denotes the fitted network card – please note that a firmware update
will be required if the network card is changed. Please see page 37 for more
information on this.
5: Output Metering
These analogue meters show the absolute output level for each channel on the
unit and are affected by remote level control adjustments and mutes. They are
for approximate signal indication only and not designed for system alignment.
Page 10
4
5
6
7
8
0dB
-3
-12
-18
2
MC
1
2
3
NETWORK
POWER
RS485
LINK
ACTIVE
ON
RX
TX
9
10
11
12
13
14
15
0dB
-3
-6
-12
-18
Ti
MULTICHANNEL NETWORK OUTPUT
Breakout Operator's Manual
5
16
ICORE
S\U
Advertisement
Table of Contents
