Removing The Printer Module - ZOLL Propaq MD Service Manual

Removing the Printer Module

Tools Required
#1 Phillips screwdriver with torque capability
•
Orange (wooden) stick
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
To reinstall the printer module, reverse the steps.
Printer Disassembly
1 Place the unit screen down on the mat in a
horizontal position.
2 Open the printer housing and remove the
printer paper.
3 Remove the two (2) screws inside the
printer module in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
4 Remove the two (2) screws on the outside
of the printer.
Note: During reassembly, torque screws to
6 in-lbs.
5 Slowly remove the printer from the unit,
being careful not to strain the cables.
58 9650-0801-01 Rev B