Installing Or Replacing A Device In The Optical/Storage Combination Enclosure - Lenovo ThinkStation P310 User Manual

6. Slide the bracket with the new hard disk drive into the front-access storage enclosure until it snaps into
position. Press the notch to secure the enclosure cover and lock it with the key.
Figure 49. Installing the hard-disk-drive bracket
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 101.
Installing or replacing a device in the optical/storage combination
enclosure
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Installing or replacing a device in the optical/storage combination enclosure involves the following operations:
• "Installing or replacing a hard disk drive in the optical/storage combination enclosure" on page 75
• "Installing or replacing a slim optical drive in the optical/storage combination enclosure" on page 77
Note: For a flex storage enclosure, the information about installing or replacing a hard disk drive also applies.
Installing or replacing a hard disk drive in the optical/storage combination enclosure
To install or replace a hard disk drive in the optical/storage combination enclosure, do the following:
1. Slide the enclosure out of the chassis. See "Installing or replacing an optical drive" on page 62.
2. Pinch the two clips toward each other as shown to open the rear cover of the enclosure.
Figure 50. Opening the enclosure from the rear
.
Chapter 7 Installing or replacing hardware
75