Lenovo ThinkStation P310 User Manual page 75

To install or replace an optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 54.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 54.
4. Press the release tab
Figure 24. Pivoting the drive bay assembly upward
5. If you are installing a new optical drive, do the following:
a. Remove the metal static shield from the bay.
b. Locate the optical-drive retainer from the left side of the computer. Push the optical-drive retainer
downwards to unlock the retainer. Then lift the optical-drive retainer out of the chassis.
If you are replacing an optical drive, do the following:
a. Disconnect all cables from the rear of the optical drive.
1 as shown and pivot the drive bay assembly upward.
.
Chapter 7 Installing or replacing hardware
63