Lenovo ThinkStation P310 User Manual page 80

6. Position the flex module cover on the flex module so that the rail guides on the bottom of the cover
engage the rails on the flex module. Then, push the cover to the front until it snaps into position.
Figure 34. Reinstalling the flex module cover
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 101.
Installing or replacing a card reader in the flex module
To install or replace a card reader in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Installing or replacing an optical drive" on page 62.
2. Lift the clip on the rear of the flex module and slide the flex module cover to the rear to remove the cover.
Figure 35. Removing the flex module cover
3. If you are replacing a card reader, do the following:
a. Disconnect the card reader cable from the system board. See "Parts on the system board" on page 6.
68
ThinkStation P310 User Guide