1. Install the solid-state drive into the storage converter. Then, install the four screws to secure the
solid-state drive to the storage converter.
Figure 57. Installing the solid-state drive into the storage converter
2. To install the solid-state drive with the storage converter into the 3.5-inch hard-disk-drive bracket, flex
the bracket and align pin
the storage converter.
Figure 58. Installing the storage converter together with the solid-state drive into the hard-disk-drive bracket
3. Install the storage converter with the bracket into the desired hard-disk-drive bay. See "Replacing the
primary hard disk drive" on page 90 or "Replacing the secondary hard disk drive" on page 92.
4. Connect the signal cable and the power cable to the solid-state drive.
1
, pin
2
, pin
3
, and pin
4
on the bracket with the corresponding holes in
.
Chapter 7
Installing or replacing hardware
79