Lenovo ThinkStation P310 User Manual page 82

5. Note the orientation of the new card reader and route the card reader cable into the cable clip. Hold
the clip on the card-reader retaining bracket to insert the new card reader into the card reader slot in
the flex module. Ensure that the card reader snaps into position.
Figure 39. Installing the card reader in the flex module
6. Position the flex module cover on the flex module so that the rail guides on the bottom of the cover
engage the rails on the flex module. Then, push the cover to the front until it snaps into position.
Figure 40. Reinstalling the flex module cover
7. Connect the card reader cable to the USB 2.0 connector on the system board. See "Parts on the
system board" on page 6.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 101.
Installing or replacing an eSATA connector or IEEE 1394 connector in the flex module
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Remove the flex module out of the chassis. See "Installing or replacing an optical drive" on page 62.
70
ThinkStation P310 User Guide