Turning The Power Supply Unit On - Olympus BX-URA2 Instruction Manual

UIS Series
Objective
UPlanApo 4X
10X
10X O
10X W
20X
20X
40X
40X
60X
60X
100X
PlanApo 40X
60X
100X
UPlanFI 4X
10X
20X
40X
60X
100X
UApo 20X
20X
40X
40X
40X
¦ : Recommended combination.
¦* : Usable, but image be dark depending on NA.
– – : Not usable, or applicable objective is not available.
¦** : A phase contrast (Ph) objective is necessary for phase contrast observation. The Ph objective is not
available for the UPlanFI100XOI3.
4

Turning the Power Supply Unit On

Set the main switch to " I " (ON). The arc will stabilize in 5 to 10 minutes after ignition.
}The discharge type mercury burner may not be ignited from the beginning on rare occasions due to its characteristics.
In this case, set the main switch to "
# To extend the mercury burner life, do not turn the mercury burner off for 15 minutes after ignition.
# The mercury burner cannot be reignited until the mercury vapor has cooled down and liquefied. Before re-igniting
a mercury burner, wait for about 10 minutes after the last time it was turned off.
}For the shake of safety, the power supply to the lamp housing is shut down if the lamp housing is opened while the burner
is on. If this happens, set the main switch to "
open the lamp housing until it has cooled down enough.
# To reset the hour counter, hold its reset button till "000.0" is displayed.
Reflected light fluorescence
U, V, BV
¦
¦
¦
¦
¦
O3 ¦
¦
O Ι 3
¦
¦
W3 ¦
O Ι 3
¦
–
O3 ¦
O3 –
¦*
¦*
¦*
¦*
O Ι 3
¦
O, OΙ3 ¦
3/340
¦
W3/340
¦
3/340
¦
OΙ 3/340
¦
W3/340
¦
" (OFF), wait for 5 to 10 seconds, then set it again to " I " (ON).
" (OFF), wait for more than 10 minutes, then set it again to " I " (ON). Do not
Phase contrast
difference
B, IB, G, IY
¦ –
¦ ¦**
¦ –
¦ –
¦ ¦**
¦ –
¦ –
¦ ¦**
¦ –
¦ –
¦ ¦**
¦ –
¦ ¦**
¦ –
¦* –
¦* ¦**
¦* ¦**
¦* ¦**
¦ ¦**
¦ ¦**
¦ –
¦ –
¦ –
¦ –
¦ –
Transmitted
light DIC
–
¦
¦
–
¦
¦
¦
¦
–
¦
¦
–
¦
–
–
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
11