Installation Procedures; Connecting The Power Cord; Figure 2.3 Rear View Of The Point Of Care Terminal - Advantech POC-S197 User Manual

2.2

Installation Procedures

2.2.1

Connecting the Power Cord

The POC-S177 can only be powered by a DC power adapter (SINPRO Model
no.HPU100-107). Be sure to always handle the power cords by holding the plug ends
only.
Follow these procedures in order:
1. Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2.3.)
2. Connect the female end of the power cord to the DC power adapter
3. Connect the 3-pin male plug of the power cord to an electrical outlet.
Warning! POC-S197/S177/S157 is supplied by a 100 watt power supply and a
special adapter.
If a medical adaptor is connected to the POC-S177, the customer must
ensure legal and regulatory compliance that the device meets the law
and standards compliance requirements of this hardware.
Switching on the power
Switch on the power switch on the back I/O for POC-S177/S157 (The color indicator
is green).
Push down the power button on the front panel for POC-S197 (The color indicator is
green).

Figure 2.3 Rear view of the point of care terminal

11 POC-S197/S177/S157 User Manual