Table of Contents
Advertisement
19
. SWITCHES/HORN/FUEL UNIT/THERMOSTATIC SWITCH
/TEMPERATURE GAUGE/INSTRUMENTS/LIGHTS
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• After installation of each switch, a continuity check must be performed. A continuity check can
usually be made without removing the part from the motorcycle.
TESTING INSTRUMENT
Electric tester
SPECIAL TOOL
Fuel unit wrench
TROUBLESHOOTING
Lights do not come on when ignition
switch is "ON"
• Burned bulb
• Faulty switch
• Poorly connected, broken or shorted wire
Fuel gauge pointer does not move or
register correctly
• Faulty fuel gauge
• Faulty fuel unit
• Poorly connected wire between fuel
gauge and fuel unit
• Fuse burned out
SPECIFICATIONS
Fuse
Headlight bulb
Turn signal light bulb
Stoplight/taillight
License plate light
Position light
Turn signal indicator light
Temperature gauge does not register
correctly
• Faulty temperature gauge
• Faulty thermosensor
• Broken or shorted wire between
temperature gauge and thermosensor
10A,15A,30A
12V 60W/55W
12V 10W
12V 21/5W
12V 5W
12V 5W
12V 3.4W
GRAND DINK
250
19-2
Advertisement
Chapters
Table of Contents
Troubleshooting
