Using The Poe; Lan Cable Connection - JVC VN-X35U Instructions Manual

Connection / Installation
Power Connection (continued)
● In a system where multiple units of VN-X35U
are used, turn on the power of only one unit
to configure the IP address settings using the
Internet Explorer. Upon doing so, turn on the
power of the second unit and configure
accordingly. Configure the camera settings
using the same procedure.
● When there is an overlap of IP address, access
to VN-X35U may fail. When this occurs, turn on
the power of only one VN-X35U unit within the
same LAN environment and wait for a while (at
least 10 minutes). Alternatively, turn off the
power of all network devices connected to the
same LAN environment, followed by turning
them on again.

Using the PoE

Connect to a device that supports PoE to supply
electricity from the LAN cable.
1 2
AC24V
MONITOR
OUT
SEE INSTRUCTION MANUAL
CAUTION
PoE
: NEVER USE AND
DO NOT CONNECT TO THE TELEPHONE NETWORK
Memo:
● For details on the connection method and
cable type, please refer to ALAN Cable
ConnectionB (A Page 18).
What is PoE (Power over Ethernet)?
This is a function that enables operation of a
LAN equipment without a power cable by
supplying power simultaneously with the data
using a LAN cable.
18
G 2 1 2 1
ALARM
AUDIO
10BASE-T/
100BASE-TX
AC 24V
AT THE SAME TIME
PUSH
Connect to PoE-
compatible device

LAN Cable Connection

Connect the camera to a hub or computer using
a LAN cable.
Cable to use
● Shielded cable
● Length of 100 m or shorter
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a cross cable.
1 2
1 2
AC24V
AC24V
MONITOR
OUT
MONITOR
SEE INSTRUCTION MANUAL
OUT
CAUTION
PoE
: NEVER USE
DO NOT CONNECT TO THE TELEPHONE NETWORK
SEE INSTRUCTION MANUAL
CAUTION
PoE
: NEVER USE
DO NOT CONNECT TO THE TELEPHONE NETWORK
Note:
● However, cross cables cannot be used with
some computer models. When connecting
VN-X35U directly to a computer, check the
computer's LAN specifications in advance.
Memo:
● Make use of a Category 5 (or higher) cable
when 100BASE-TX is used.
● To distribute images to the network.
A
set the [MONITOR OUT]switch at the side of
this product to AOFFB.
B
Press the [RESET] button for less than 2
seconds to restart.
[MONITOR OUT] Switch [RESET] button
MONITOR OUT
G
2 1 2 1
G
2 1 2 1
ALARM
ALARM
AUDIO
10BASE-T/
100BASE-TX
AUDIO
AC 24V
AND AT THE SAME TIME
10BASE-T/
PUSH
100BASE-TX
AC 24V
AND AT THE SAME TIME
PUSH
PAL OFF NTSC RESET
STATUS
IRIS