Completing The Parts Replacement - Lenovo ThinkCentre M700 Hardware Maintenance Manual

To install the microprocessor socket cover, do the following:
1. After you have removed the microprocessor from the failing system board, close the microprocessor
retainer. Then, put the lever to the locked position to secure the retainer in place.
2. Note the orientation of the socket cover, and install one side of the socket cover into the microprocessor
socket. Carefully press the other side of the socket cover downward until the socket cover snaps
into position.
3. Carefully check the four corners of the socket cover to ensure that the cover is seated securely.
4. Follow any additional instructions that are included with the replacement part you received.

Completing the parts replacement

After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 63.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Computer components" on page 32 for the locations of various
components in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
3. Position the computer cover on the chassis so that the rail guides on the bottom of the computer cover
engage the rails on the chassis. Then, push the cover to the front of the computer until it snaps into
position. Install the two screws to secure the computer cover.
Figure 72. Installing the computer cover
4. Place the computer in an upright position.
5. If a locking device is available, use it to lock the computer. See "Locking your computer" on page 57.
6. Reconnect the external cables and power cords to the corresponding connectors on the computer.
See "Hardware locations" on page 27.
7. Update your configuration. See "Using the Setup Utility program" on page 63.
.
Chapter 9 Installing or replacing hardware
129