Lenovo ThinkCentre M700 Hardware Maintenance Manual page 93

Message/Symptom
Computer will not perform a Wake On LAN
Dead computer. See "Hard disk drive boot error" on page
82.
Diskette drive in-use light remains on or does not light
when drive is active.
Blank screen except for flashing cursor.
Incorrect memory size during POST
"Insert a Diskette" icon appears with a known-good
diagnostics diskette in the first 3.5-inch diskette drive.
Intensity or color varies from left to right of characters
and color bars
No power or fan not running
Non-system disk or disk error-type message with a
known-good diagnostic diskette.
Other display symptoms not listed above (including blank
or illegible display)
Power-on indicator or hard disk drive in-use light not on,
but computer works correctly
Printer problems
FRU/Action
®
(if applicable) 1. Check power supply and signal cable connections
to network adapter.
2. Ensure that the operating system settings are set to
enable Wake on LAN.
3. Ensure Wake On LAN feature is enabled in
Setup/Configuration (see "Starting the Setup Utility
program" on page 63)
4. Ensure network administrator is using correct MAC
address.
5. Ensure no interrupt or I/O address conflicts.
6. Network adapter (advise network administrator of
new MAC address)
1. Power Supply
2. System Board
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. System Board
2. Primary Hard Disk Drive
3. Hard Disk Drive Cable
1. Run the Memory tests.
2. Memory Module
3. System Board
1. System Board
2. Diskette Drive Cable
3. Network Adapter
1. Display
2. Video adapter (if present)
3. System Board
1. See "Hard disk drive boot error" on page 82.
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. Display
2. System Board
1. Power switch/LED assembly
2. System Board
1. Printer
2. System Board
Chapter 8
.
Service checkout and symptom-to-FRU index
85