Chapter 4. Completing The Parts Replacement; Installing The Cover - Lenovo ThinkCentre 6068 Hardware Installation And Replacement Manual

Chapter 4. Completing the parts replacement

After working with parts, you need to replace the computer cover and reconnect
any cables, including telephone lines and power cords. Also, depending on the
part that was replaced, you might need to confirm the updated information in the
Setup Utility program.
To replace the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Reposition any cables that might impede the replacement of the computer
3. If the drive bay assembly was removed, align it with the two slots and rails on
4. Slide the drive bay assembly towards the rear of the chassis until it snaps into
5. Reinstall the front bezel if it was removed.
6. Position the computer cover on the chassis so that the rail guides on the sides
Figure 39. Installing the cover
7. Install any locking devices such as a padlock as necessary.
8. Reconnect the external cables and power cords to the computer. See "Locating
9. To update the configuration, see "Using the Setup Utility" in the User Guide that
© Lenovo 2006, 2007. Portions © IBM Corp. 2005.
or loose screws are left inside your computer.
cover.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
the sides of the chassis and reconnect the drive cables to the system board.
position.
of the cover engage the rails and push the cover to the closed position until it
snaps into position. If your computer has screws to secure the computer cover,
install the screws.
connectors on the rear of your computer" on page 5.
was included with your computer.
35