Flow Rate; Totalizer; Batch - Siemens MAG 1100 Handbook


SITRANS F M MAGFLO
8.5.1

Flow rate

8.5.2

Totalizer

8.5.3

Batch

(Only available on
MAG 6000)
Batch cycle counter
Batch cycle counter reset
68
8. Commissioning
st
The 1 display line is always active and shows the value enabled in the operator menu setup.
•
Flow rate
•
Totalizer 1
•
Totalizer 2
nd rd
The 2 and 3 display lines are individually set in the operator menu. The page forward key steps
through the enabled settings.
•
Flow rate
•
Totalizer
•
Totalizer reset
•
Batch control
•
Batch cycle counter
•
Batch cycle counter reset
•
Pipe size
•
Sensor type
•
Pending errors
•
Status log
•
Tag No.
A totalizer is reset by pressing the lock key when the corresponding totalizer reset window is open.
A batch can be started, paused or stopped from the operator menu, in addition to the externally
operated batch control. The batch is controlled using the lock and the top up keys.
The lock key:
•
Starts the batch
•
Holds the batch (pause) when pressed during batching
•
Restarts the batch to continue when pressed during a pause.
The top up key resets a batch completely during a pause.
The accumulated number of performed batches can be viewed when enabled in the operator menu
setup.
The batch cycle counter is reset by pressing the lock key in the "batch cycle cnt reset" menu.
DKFD.PS.027.W3.02
Operator menu