Signal Converter Cleaning Unit - Siemens MAG 1100 Handbook


SITRANS F M MAGFLO
6.4
Signal converter
Cleaning unit
50
6. Installation of signal converter
1. Fit the SENSORPROM ®
The SENSORPROM ® unit is delivered mounted in the terminal box of the sensor. The
connection board supplied with the signal converter is not used.
2. Mount the guide rails into the rack system as shown. Distance between guide rails is 20 TE.
Guide rails are supplied with the rack system and not with the signal converter.
3. Mount the connection board as shown. The mounting screw must be installed just in line with
the guide rails.
4. Connect the cables as shown under "Electrical connection", chapter 7.
5. Select AC-cleaning or DC-cleaning mode at the switch located on the base of the cleaning unit.
6. Insert the cleaning unit and the signal converter into the rack system.
DKFD.PS.027.W3.02
memory unit on the connection board supplied with the cleaning unit.