Mounting Of Signal Converter Compact Or Remote; Display And Keypad - Siemens SITRANS F C MASSFLO MASS 6000 Ex-d Manual

SITRANS F C MASSFLO
2.8 Mounting of signal
converter compact or
remote
Compact Ex-d version
Remote Ex-d version

2.9 Display and keypad

8
    
2. Installation
SFIDK.PS.028.Q1.02
For compact installation mount the converter
on top of the sensor interface. Please make
sure that it is correctly oriented (note the little
tap).
After fitting it can be turned 0-360°.
The converter is fastened with 4 allen screws
(Allen key M4).
For mechanical mounting refer to instruction
DKFD.PI.028.T1.52 supplied with the mount-
ing kit.
The terminals for inputs, outputs and power
supply can be accessed by removing the front
cover, turning it counter-clockwise.
The display can be lifted off (i.e. with the tip of a
screwdriver or similar) and the terminals are
accessible.
The display/keypad can be rotated in steps of
90°. Please note the little tap on the back of the
display frame which must correspond to the
nut at the converter body when the display/
keypad is replaced. This is essential for obtain-
ing optimum sealing.