Configuring The Rip - Hirschmann MACH 4000 User Manual

RIP

6.4 Configuring the RIP

The advantage of RIP is the simple configuration. After the router interface
is defined and the RIP is switched on, RIP automatically enters the required
routes in the routing table.
Subnet 10.0.1.0/24
IP = 10.0.1.5/24
GW =10.0.1.1
Interface 2.1
IP=10.0.1.1
Figure 24: Example of the configuration of RIP
The configuration of RIP requires the following steps:
Configure router interfaces - assign IP address and network mask.
Switch on RIP on port.
Switch on RIP globally.
Switch on routing globally (if this has not already been done).
Configuration for Router B
enable
configure
interface 2/2
ip address 10.0.3.1
255.255.255.0
routing
exit
64
Interface 2.1
IP=10.0.2.2
A
Interface 2.2
IP=10.0.2.1
Switch to the Priviledged EXEC mode.
Switch to the Configuration mode.
Switch to the Interface Configuration mode of
interface 2.2.
Assign the IP parameters to the port.
Switch on the router function at this port.
Switch to the Configuration mode.
6.4 Configuring the RIP
Subnet 10.0.3.0/24
IP = 10.0.3.5/24
GW = 10.0.3.1
B
Interface 2.2
IP=10.0.3.1
Release 4.0 11/07
Routing L3P