Multicast Routing
9.5.2 Example with Layer 2 redundancy
(HIPER-Ring)
VLAN 1 is assigned to the HIPER-Ring.
Assign other VLAN IDs to the connected VLANs and leave the HIPER-
Ring on its own in VLAN 1. You thus enable the transmission of the
Multicast data streams on Layer 3.
If you assign multiple VLANs to the HIPER-Ring as transfer networks, then
the Switch transmits the Multicast data streams to every transfer network
during the flood and prune phases. This means that the Switch transmits the
Multicast data streams to every VLAN and the network load is thus multiplied
in the HIPER-Ring.
IP: 10.0.1.2/24
GW: 10.0.1.1
Interface: 9.2
VLAN 2
IP: 10.0.1.1/24
Figure 38: Multicast example configuration with HIPER-Ring
112
IP: 10.0.3.12/24
VLAN 3
GW: 10.0.3.1
Interface: 9.2
IP: 10.0.3.1/24
Interface: 9.1
A
IP: 10.0.10.3/24
HIPER-Ring
VLAN 1
Interface: 9.1
IP: 10.0.10.1/24
Interface: 9.1
C
IP: 10.0.10.1/24
9.5 Multicast Configuration
IP: 10.0.3.11/24
GW: 10.0.3.1
Interface: 9.2
IP: 10.0.3.1/24
Interface: 9.1
IP: 10.0.10.3/24
Interface: 9.1
IP: 10.0.10.2/24
Interface: 9.1
IP: 10.0.10.2/24
B
RM
IP: 10.0.2.0/24
Routing L3P
Release 4.0 11/07