Router Interface - Hirschmann MACH 4000 User Manual

Appendix
Give all the layer 2 and layer 3 switches their IP parameters in accordance
with the network plan.
You can access the devices in subnets 10 to 14 again when you have
completed the following router configuration.
Configure the router function for the layer 3 switches.
Note the sequence:
1. Layer 3 switch C
2. Layer 3 switch B
The sequence is important; you thus retain access to the devices.
As soon as you assign an IP address from the subnet of the management
IP address (= SN 100) to a router interface, the Switch deletes the
management IP address. You access the Switch via the IP address of the

router interface.

IP = 10.0.200.11/24
Port 2.1:
VLAN 1 (Management IP=10.0.100.101)
--> IP= 10.0.10.1/24
GW: 10.0.200.10
Port 1.1:
VLAN 1
Interface 9.1
IP = 10.0.100.1/24
GW: 10.0.200.10
Figure 41: IP parameters for layer 3 switch A
126
Port 2.2:
IP = 10.0.200.10/24
GW: 10.0.200.11
A
HIPER-Ring
SN 100
10.0.100.0
VLAN 1
Port 1.2:
VLAN 1
Interface 9.1
IP = 10.0.100.1/24
GW: 10.0.200.10
A.5 Entering the IP Parameters
Port 3.1 - Port 3.4:
VLAN 2
Interface 9.2
IP = 10.0.11.1/24
GW: 10.0.200.10
Routing L3P
Release 4.0 11/07