Configuring Ospf - Hirschmann MACH 4000 User Manual

OSPF

7.6 Configuring OSPF

In the state on delivery, the default values are selected so that you can
configure simple OSPF functions in just a few steps.
After the router interface is defined and OSPF is switched on, OSPF
automatically enters the required routes in the routing table.
The example (see fig. 30)
already defined in the state on delivery. The terminal devices do not have an
OSPF function, so you do not have to activate OSPF on the corresponding
router interface. By activating the redistribute function, you can inject the
routes to the terminal devices into the OSPF.
Subnet 10.0.1.0/24
IP=10.0.1.5/24
GW=10.0.1.1
Interface 2.1
IP=10.0.1.1
Figure 30: Example of the configuration of OSPF
The configuration of OSPF requires the following steps:
Configure router interfaces – assign IP address and network mask.
Switch on OSPF at port.
Switch on OSPF globally.
Switch on routing globally (if this has not already been done).
84
shows a simple OSPF configuration. Area 0 is
Interface 2.1
IP=10.0.2.2
A
Interface 2.2
IP=10.0.2.1
7.6 Configuring OSPF
Subnet 10.0.3.0/24
IP=10.0.3.5/24
GW=10.0.3.1
B
Interface 2.2
IP=10.0.3.1
Release 4.0 11/07
Routing L3P