Chaining Effects - Akai s2000 Owner's Manual

E F F E C T S

CHAINING EFFECTS

Not only is it possible to have the multi-effects with distortion/EQ>mod/delay>reverb on FX1
and FX2 but you may also feed the outputs of these two channels to the 'spare' reverb
channels RV3 and RV4. This allows you to add reverb to reverb. At first this may seem a bit
pointless but one use that immediately springs to mind is adding a hint of 'acoustic' reverb to a
gated or reverse reverb effect. This is done in the REVERB 3 SOURCE page.:
You may select RV3's input. You may select from the following options:
RV3
FX1
FX1
DIST/EQ
FX1 DIST/EQ
DIST/EQ
Page 166
RV3 will be fed with whatever is routed to RV3 in the SINGLE
or MULTI modes or in EDIT SINGLE, keygroup FX page.
This will route anything routed to the FX1 buss to RV3.
This allows you to send one sound (internal or external to two reverbs.
The output of the distortion/EQ section of FX1 will be fed to RV3:
MOD/ECHO
PATH
PATH CONTROL
PATH
REVERB
RV3 REVERB
MOD/ECHO
PATH
PATH CONTROL
PATH
REVERB
RV3 REVERB
S2000 Operator's Manual - Version 1.30
L/R outs
L/R outs
L/R outs
L/R outs
L/R outs
L/R outs