Table of Contents
Advertisement
Product Description
LEDs
Table 1 shows lists and defines the port and system LEDs.
LED
TX
RX
COL
LINK
FD
100
FORWARD
(system)
POWER (system)
Configuration Switch
The switch provides an externally accessible Configuration Switch to select
operating speeds (10 Mbps or 100 Mbps) and duplex mode (half or full),
making it suitable for switching between 10, 100 or 100 and 100 Mbps
networks, as needed.
Use the DIP switch to configure the speed and duplex mode for each port. The
DIP switch should be set as shown in the following:
Duplex Mode
Down = Full Duplex
Up = Half Duplex
6
Table 1: Port and System LEDs
Color
Green
ON indicates that the switch is transmitting signals
Green
ON indicates that the switch is receiving signals
Yellow
ON indicates data collisions (half duplex mode)
Green
ON indicates that the link connection is established
Yellow
ON for FULL Duplex mode indicates simultaneous
(two-way), independent transmission
OFF for HALF duplex mode indicates transmission in
only one direction at a time. Both devices contend for
the right to send data when active transmission is not
occurring.
Green
ON indicates the operating speed is 100 Mbps
OFF means 10 Mbps
Green
ON indicates that the LAN switch is forwarding a
packet from one port of a switch to the other
Green
ON indicates that the switch is powered on
Description
Speed (Mbps)
Down = 100 Mbps
Up = 10 Mbps (TX only)
Advertisement
Table of Contents
Troubleshooting
