Fitting And Adjusting The Optional Rigging Frame; Fitting; Stacking; Pitch, Roll And Yaw - Digital Projection Titan Pro Series 3 Installation And Quick Start Manual

Digital Projection
Titan Pro Series 3

Fitting and adjusting the optional rigging frame

Fitting

•
Remove the four adjustable feet.
•
Secure the rigging frame to the projector, as shown, making sure that the male frame
couplings are at the top. Secure each adaptor plate to the projector (three screws), and
secure each of the adjuster brackets to an adaptor plate (three screws).

Stacking

The projectors can be stacked on top of each other, or suspended below each other.
•
Carefully lower each projector down onto the top of the others, making sure that all four
frame couplings engage fully.
Vertical
adjusters
•
Fit a locking pin into each coupling. A ball in the end of the pin prevents the pin from
falling out – to insert or remove a locking pin, press the button on the end of the pin to
release the ball.

Pitch, Roll and Yaw

•
To adjust the pitch, turn either the front pair or the rear pair of vertical adjusters, taking
care to turn both adjusters by the same amount.
•
To adjust the roll, turn either the left pair or the right pair of vertical adjusters, taking care
to turn both adjusters by the same amount.
•
To adjust the yaw, turn the single horizontal adjuster at the front.
Rev D November 2012
POSITIONING THE SCREEN AND PROJECTOR
Frame
couplings
Horizontal
adjuster
Pitch
Fixing
screws
(2 x 3)
Locking
pin
Roll Yaw
Installation and Quick-Start Guide
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Do not place the projector with its
front panel down on a surface, as
this may damage the lens or the
lens release lever.
Do not stack more than 3
projectors.
Do not place heavy objects on top
of the projector chassis. Only the
chassis corners and the rigging
frame are capable of withstanding
the weight of another projector.
Backup safety chains or wires
should always be used with
ceiling mount installations.
Inst 6