Configuring Device Settings - Ruckus Wireless ZoneFlex T301s User Manual

Configuring Device Settings

Device settings refer to the device name, location, service provider login, and other
settings. (Some settings are only available on certain AP models.)
1 Go to Configuration > Device.
Figure 28. The Configuration > Device page
2 In Device Name, type a new name for the device or leave as is to accept the
default device name (RuckusAP). The device name identifies this AP among
other devices on the network.
3 Configure the following optional settings as desired:
• Enter Device Location to keep track of the physical location of the AP.
• If the AP has a GPS antenna, then select the method of entering the GPS
coordinates. In Coordinate Source, select GPS to have the GPS antenna
automatically determine and enter the GPS coordinates, or select Manual
to enter the GPS coordinates manually.
If you selected Manual, then enter GPS Coordinates to record the physical
location of the AP.
• Under LED Control (specific models only), check the Disable Status LED(s)
box to turn off the status LEDs. This can be useful when the AP is installed
in a public location, to avoid drawing attention to the AP.
• Enable Internal Heater and PoE OUT Port (specific models only) if needed.
Ruckus Wireless Outdoor AP 100.1.0 User Guide, 800-70863-001 Rev A
Configuring Device Settings
73