Assembly Instructions - Body Solid SLS500 Owner's Manual

S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Front Base Frame (A) to Right Rear Base Frame (D)
1B. Attach Front Base Frame (A) to Left Rear Base Frame (E)
1C. Attach Center Base Frame (P) to Rear Base Frames (D &E) and
Front Base Frames (A) using:
4 - (#1) M12x130mm Hex Head Bolt
8 - (#9) M12 Flat Washer
4 - (#12) M12 Nylon Lock Nut
2 - (#14) Bracket
12