Body Solid SLS500 Owner's Manual page 18

S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
4A. Attach Weight Horns (M & N) to Squat Frame (K) using:
4 - (#2) M12x105mm Hex Head Bolt
8 - (#9) M12 Flat Washer
4 - (#12) M12 Nylon Lock Nut
4B. Attach Weight Horns (Q) to Uprights (B & C) using:
4 - (#3) M12x80mm Hex Head Bolt
8 - (#9) M12 Flat Washer
4 - (#12) M12 Nylon Lock Nut
2 - (#27) Steel Plate
WARNING:
Please ensure the Weight Horns (Q) points upward, otherwise the weight
plates may fall off.
18