Body Solid SLS500 Owner's Manual page 14

S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A. Attach Uprights (B & C) to Front Base Frame (A) using:
4 - (#1) M12x130mm Hex Head Bolt
8 - (#9) M12 Flat Washer
4 - (#12) M12 Nylon Lock Nut
2B. Attach Center Frame (G) to Uprights (B & C) and Rear Base
Frames (D & E) using:
4 - (#4) M12x30mm Button Head Cap Screw
4 - (#9) M12 Flat Washer
2C. Attach Squat Frame (K) to Rear Base Frames (D & E)
NOTE: Mininum of two persons is required for Step 2C installation.
14