Body Solid SLS500 Owner's Manual page 20

S T E P
5
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
and after STEP 5C. Some components may be pre-assembled. Nylon lock nuts will not
fully screw onto bolts, they must be wrench tighten to fully go on.
5A. Attach Shoulder Pads (#17) to Squat Frame (K) using:
8 - (#6) M8x70mm Button Head Cap Screw
8 - (#10) M8 Flat Washer
8 - (#11) M8 Lock Washer
5B. Attach Adjustment Bar (L) to Squat Frame (K) Using:
2 - (#21) Bushing
2 - (#22) Ring
2 - (#7) M6x20mm Button Head Cap Screw
5C. Attach Hooks (#23) to Adjustment Bar (L) using:
2 - (#5) M8x55mm Hex Head Bolt
4 - (#10) M8 Flat Washer
4 - (#13) M8 Nylon Lock Nut
20