Table of Contents
Advertisement
Chapter 2 Useful Features
1.2.5
Boot
If you move the cursor to Boot, the Boot menu where you can configure the boot order appears.
For details about the options, see the table below.
Option
Boot Configuration
Quiet Boot
Bootup Numlock State
Setup Prompt Timeout
Boot Mode
Boot Option Priorities
Boot Option #1
Boot Option #2
Boot Option #3
Boot Option #4
CD/DVD Priorities
HDD Priorities
Network Priorities
Parameter
−
Disabled
Enable or disable the feature to display the NEC logo during
[Enabled]
POST. When this option is set to "Disabled", the results of POST
execution are displayed instead of the NEC logo.
If BIOS Redirection Port is enabled, this option is shown as
Unavailable and inaccessible (run with "Disabled" state
automatically)
On
Enable or disable the Numlock feature of the keyboard.
[Off]
[0] - 65535
Specify the time until <F2> is pressed to launch SETUP.
Legacy
Specify the boot mode.
[UEFI]
Select "UEFI" for the following OS:
– Windows Server 2012 or Windows Server 2012 R2
Select "Legacy" for the following OS:
– Windows Server 2008 or Windows Server 2008 R2
See Chapter 1 Installing Windows in Installation Guide, and
determine the Boot Mode according to description in "Before
Starting Setup" appropriate to your OS.
−
−
These items show the priority of boot devices.
If all of the boot options are set to "Disabled", SETUP starts
−
running upon completion of POST.
−
If the Boot Mode setting is changed, the devices are displayed
−
after the system reboots.
−
Specify the boot priority for each device type.
−
−
Express5800/R120f-2E, T120f
Description
−
−
Maintenance Guide
1. System BIOS
[
]: Factory setting
97
Advertisement
Table of Contents
