System Control & Maintenance - CYBEX autoview 200 Installer And User Manual

AutoView 200 Installer/User Guide
System Control &
Maintenance
The following commands are used for system control and maintenance.
Enter the command sequences to perform the actions described in the
table below.
Key Sequence Action
<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.
<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a standard PS/2 mouse driver.
<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a loss of mouse
signal. Use this command to restore the signal if you are using a PC
with a Microsoft IntelliMouse or other wheel mouse driver.
<CM>AV<Enter> Displays the current firmware version of your AutoView 200.
<CM>SG<Enter> Enables the scan Go command (By address only)
<CM>SH<Enter> Enables the scan Halt command
<CM>M+<Enter> Enables mouse suspension of scanning
<CM>M-<Enter> Disables mouse suspension of scanning
<CM>H1<Enter> Changes the hot-key sequence to the default: (NumLock, -)
<CM>H2<Enter> Changes the hot-key sequence to the 1st alternate: (NumLock, *)
<CM>H3<Enter> Changes the hot-key sequence to the 2nd alternate: (CTRL, ~)
<CM>OSD0<Enter> Disables the OSD Sequence
<CM>OSD1<Enter> Changes the OSD sequence to the default: (CTRL, CTRL)
<CM>OSD2<Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt)
<CM>OSD3<Enter> Changes the OSD sequence to the 2nd alternate: (Shift, Shift)
<CM> <CM> <Enter> <Enter>
<CM> <CM> <CM>ZM<Enter> <Enter> <Enter> Use this command to resynchronize the mouse after a device or
computer hot-plug. Repeat, if necessary, until synchronization is
re-established.
Note: Using this command while the mouse is operating
correctly will cause the mouse to lose sync.
14