The Command Menu - CYBEX autoview 200 Installer And User Manual

The Command
Menu
Once you have activated the main OSD Window, you can open the Command
Menu by pressing either of the Control keys twice.
The Command Menu options are selected in the same manner as channels
in the OSD Window. Scroll the Highlight Bar up and down and press Enter
when your selection is highlighted.
If you are operating in non-secure mode or are the system administrator,
you will have several options that do not appear in the User level Command
Menu: Add Channel, Edit Channel, Delete Channel and Administrator
Functions are all covered in separate sections in this chapter. Scanning is
covered in Chapter 6.
If you experience a loss of mouse signal while using the AutoView 200,
select the 'Reset Standard Mouse/Keyboard' option from this menu for a
PC with a standard mouse driver or 'Reset Wheel Mouse/Keyboard' if you
are using a PC with a Microsoft IntelliMouse or other wheel mouse driver.
This will reset and in most cases restore your mouse signal. These
c o m m a n d s
<CM>MW<Enter> keyboard command listed in the 'System Control &
Maintenance' section of this manual.
Choose the option 'Version Information' to display on your monitor the
current version level of your AutoView 200 firmware. Press the Esc key to
clear this information from your screen.
CYBEX Control Panel
Administrator Command Menu
Add Channel
Edit Channel
Delete Channel
Administrative Functions
Scanning
Reset Standard Mse/Kbd
Reset Wheel Mse/Kbd
Version Information
ENTER = activate ESC = exit

THE COMMAND MENU

a r e e q u i v a l e n t
17
On-Screen Display Operations
Program Manager
is OFF
Games
t o t h e < C M > M R< E n t e r > a n d