CYBEX autoview 200 Installer And User Manual page 14

AutoView 200 Installer/User Guide
11. Locate the power cord that came with your AutoView 200 unit. Plug it
12. Power-up your AutoView 200 unit f irst, then power up all
into the IEC power connector on the AutoView 200. Make sure that the
power switch is off, then plug the other end of the power cord into an
appropriate AC wall outlet. This outlet must be near the equipment
and easily accessible to allow for unplugging prior to any servicing of
the unit.
attached computers.
The AutoView 200 and all attached computers should be
powered-down before servicing the unit. Always discon-
nect the power cord from the wall outlet.
!
H z
/ 6 0
5 0
A ,
, . 1
0 V
2 4
0 -
1 0
8
1
0