Turning Scanning On And Off - CYBEX autoview 200 Installer And User Manual

AutoView 200 Installer/User Guide
Turning Scanning
On and Off
From the OSD menu.
1. From the main OSD Window, press the Control key twice to
access the Command Menu.
2. Toggle 'Scanning OFF', 'Scan by Name' or 'Scan by address' from
the menu. This is a toggle option - only one scanning option will
show on the menu at any one time.
Selecting 'by Name' will scan channels alphanumerically by
name, 'by Address' will scan channels alphanumerically by
channel address.
3. Press Enter.
With the Scan Button
1. You may initiate scanning by address by pressing and holding the
Step/Scan push-button until the SCAN LED lights green.
2. Scanning may be halted if a channel is selected, or if the Step/
Scan push-button is pressed again.
By keyboard hot-key sequence
The following key sequences control scanning.
Key Sequence
<CM>SG<Enter>
<CM>SH<Enter>
Action
Enables the scan Go command. (By Address Only)
Enables the scan Halt command.
30